Lukas at Deszynski dot com Solar Home Monitor.
0 W
0 A
0 V
0 V
0 W
0 A
0 W
0 W
0 W
Target V:
Inv1 Data from:
Tristar Data from:
BMV Data from:
Tristar Data from:
BMV Data from:
Output Prio: | |
Back to Grid: | |
Back to Batt: | |
Mode: | |
to Grid SOC (bmv): | |
to Batt SOC (bmv): |
smartMe Meter
L1: | |
L2: | |
L3: | |
kWh: | |
Date: |
Variable | Value |
Morningstar LiveView | Morningstar DataLog |
Charge State | ".$tristar_registers_values['Charge State']." |
LED State | ".$tristar_registers_values['LED State']." |
Kilowatt Hours | ".$tristar_registers_values['Kilowatt Hours']." kWh |
Amp Hours | ".$tristar_registers_values['Amp Hours']." Ah |
Batt Target Voltage | ".$tristar_registers_values['Target Voltage']." V |
Today Watt Hours | ".$tristar_registers_values['Today Watt Hours']." Wh |
Today Max. Output Power Watts | ".$tristar_registers_values['Today Max. Output Power Watts']." W |
Today Absorption | ".$tristar_registers_values['Today Absorption']." sec |
Today Float | ".$tristar_registers_values['Today Float']." sec |
Daily_Faults | ".$tristar_registers_values['Daily_Faults']." |
Daily_Alarms_hi | ".$tristar_registers_values['Daily_Alarms_hi']." |
Daily_Alarms_lo | ".$tristar_registers_values['Daily_Alarms_lo']." |
flags_daily | ".$tristar_registers_values['flags_daily']." |
Sweep Vmp | ".$tristar_registers_values['Sweep Vmp']." V |
Sweep Voc | ".$tristar_registers_values['Sweep Voc']." V |
Sweep Pmax | ".$tristar_registers_values['Sweep Pmax']." W |
Variable | Value |
Variable | Value |
Inverter | Conversol 5k |
AC_IN_V | n.d. |
AC_IN_HZ | n.d. |
AC_OUT_V | n.d. |
AC_OUT_HZ | n.d. |
AC_OUT_VA | n.d. |
AC_OUT_W | n.d. |
AC_OUT_LOAD_PERCENT | n.d. |
BUS_V | n.d. |
BATT_V | n.d. |
BATT_CHRG | n.d. |
BATT_CAPACITY_PERCENT | n.d. |
HEATSINK_TEMP | n.d. |
PV_I_BATT | n.d. |
PV_V | n.d. |
BATT_V_SCC | n.d. |
BATT_DISCHRG_I | n.d. |
Device Status | n.d. |
Device Mode | n.d. |